Guitar Tuner

Tune guitar, bass or ukulele with your microphone: note, cents meter and reference tones for each string

Share this tool

Report a problem

Describe the problem without including private input or files.

How useful was this tool?

How useful was this tool?

Tuner

Turn on the microphone, then pluck one string at a time.

-
Pitch frequency
-
Target pitch
-
Offset in cents
-

Instrument strings

Tap a string to hear its note. Tap it again to stop it.

Tuner settings

Tuning mode

Matches the nearest string of the selected tuning.

Note names
Reference pitch A4

Standard is 440 Hz. Allowed range 430 to 450 Hz.

About Guitar Tuner

Guitar Tuner listens through your phone or laptop microphone and shows the note you play, its frequency to a tenth of a hertz and how many cents it sits above or below the target. In automatic mode it works out which string you plucked, so the six string buttons light up as you go from low E to high E. The needle settles when the reading is steady and the center turns green within 5 cents of the target pitch, which is closer than most ears can hear on a single string.

It covers the tunings people actually use: standard E A D G B E, Drop D, half step down, open G, open D and DADGAD on guitar, the four-string bass down to its 41.2 Hz low E, and G C E A ukulele. Switch to chromatic mode for anything else, from a mandolin to a violin. The reference pitch can be moved from 430 to 450 Hz when you play along with a recording or an orchestra that does not tune to A = 440 Hz.

Each string button also plays its note as a reference tone, so you can tune by ear and check the result on the meter afterwards. The tuner pauses while the tone sounds so it does not read the speaker instead of the string. The sound from the microphone is never recorded or uploaded, and the microphone turns off when you leave the page.